Diagnostic
Engine does not stop when lanyard cord is pulled
Cause: Faulty lanyard stop switch Test: Start engine, pull lanyard cord, and observe whether engine stops
Diagnostic
Cause: Faulty lanyard stop switch Test: Start engine, pull lanyard cord, and observe whether engine stops
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 4–5 feet conditions={"state":"stretched"}
Procedure · 1. Start the engine. 2. Stop the engine by pulling the lanyard cord to verify the stop switch operates correctly. 3. If the engine does not stop when the lanyard cord is pulled, have the switch repaired before operati...
Spec · 122–152 cm conditions={"state":"stretched"}
Procedure · 1. Insert the element on one end of the lanyard cord into the lanyard stop switch (c). WARNING: Read all Important Safety Information before proceeding. 2. Attach the clip on the other end of the lanyard cord (a) to t...
Diagnostic · Cause: Lanyard stop switch not properly attached or lanyard too long/slack Test: Verify lanyard is clipped to operator's PFD or wrist and inserted into switch; check lanyard length is 122–152 cm (4–5 ft) when stretched