Procedure
1. Start the engine. 2. Stop the engine by pulling the lanyard cord to verify the stop switch operates correctly. 3. If the engine does not stop when the lanyard cord is pulled, have the switch repaired before operating the boat. WARNING: Do not operate the boat if the lanyard stop switch is not functioning properly.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 4–5 feet conditions={"state":"stretched"}
Diagnostic · Cause: Faulty lanyard stop switch Test: Start engine, pull lanyard cord, and observe whether engine stops
Spec · 122–152 cm conditions={"state":"stretched"}
Procedure · 1. Visually inspect the entire lanyard cord for any breaks, cuts, or wear. 2. Check that the clips on both ends of the cord are in good condition. 3. Replace any damaged or worn lanyard cords before operating the boat...
Diagnostic · Cause: Lanyard stop switch not in RUN position