Starter Motor Will Not Crank the Engine

Related KB links

• Engine: Shallow Water Operation - Max Engine Speed (Tilted)

  Spec · 2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}

• Lanyard Stop Switch Pre-Use Functional Check

  Procedure · 1. Start the engine. 2. Stop the engine by pulling the lanyard cord to verify the stop switch operates correctly. 3. If the engine does not stop when the lanyard cord is pulled, have the switch repaired before operati...

• Outboard motor oil sump: Oil level operating range

  Spec · Cross hatched region on dipstick conditions={"note":"Do not fill to top of operating range; any level within cross hatched region is acceptable"}

• Stopping the Engine (DTS System)

  Procedure · 1. Turn the key to the OFF position to stop the engine normally. WARNING: Turning the key to the START position while the engine is running will result in engine shut down while leaving the DTS system active. This all...

• Starter Motor Will Not Crank the Engine

  Diagnostic · Cause: Ignition key switch failure