Procedure
1. Turn the key to the OFF position to stop the engine normally. WARNING: Turning the key to the START position while the engine is running will result in engine shut down while leaving the DTS system active. This allows use of the power trim/tilt from the remote control handle but is not the intended stopping procedure.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Tighten until seats, then back off 1/4 turn
Diagnostic · Cause: Key switch is not in the Run position Test: Verify key switch is set to Run position before using the Stop/Start button
Spec · Mercury Verado NMMA FC-W certified SAE 25W-40 Synthetic Blend Marine 4-Stroke Engine Oil conditions={"use":"General, all-temperature use"}
Procedure · 1. Never shift the outboard into gear unless engine speed is at idle. Do not shift outboard into forward or reverse when the engine is not running. WARNING: Shifting into gear above idle speed or when engine is not ru...
Diagnostic · Cause: Shift actuator failure Test: Turn ignition key switch off to reset and then start the engine