Diagnostic
Stop/Start switch does not function
Cause: Key switch is not in the Run position Test: Verify key switch is set to Run position before using the Stop/Start button
Diagnostic
Cause: Key switch is not in the Run position Test: Verify key switch is set to Run position before using the Stop/Start button
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 4–5 feet conditions={"state":"stretched"}
Procedure · 1. Start the engine. 2. Stop the engine by pulling the lanyard cord to verify the stop switch operates correctly. 3. If the engine does not stop when the lanyard cord is pulled, have the switch repaired before operati...
Spec · 75 Nm conditions={"imperial_equivalent":"55 lb-ft","note":"Transom must not yield or crack under this torque; if it does, transom must be strengthened or load carrying area increased"}
Procedure · 1. Ensure both the active helm station and the intended destination helm station are manned. WARNING: Never leave the active station while the engine is in gear. One-person helm transfer should only be performed while...
Diagnostic · Cause: Shift actuator failure Test: Turn ignition key switch off to reset and then start the engine