Procedure
Cowl Lock Removal
1. Remove the six screws securing the cowl lock and remove the lock. Retain the two hex nuts that are used to fasten the top two screws. WARNING: Retain the two hex nuts that are used to fasten the top two screws.
Procedure
1. Remove the six screws securing the cowl lock and remove the lock. Retain the two hex nuts that are used to fasten the top two screws. WARNING: Retain the two hex nuts that are used to fasten the top two screws.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 25 Nm conditions={"fastener":"top screws with hex nuts (2)","lb_in":"89"}
Diagnostic · Cause: Ice formed at the water level inside the outboard driveshaft housing, blocking the water passage to the engine Test: Check driveshaft housing for ice blockage if engine overheats after exposure to freezing cond...
Spec · Torque to specifications conditions={"note":"Torque bolt first, then torque locknut"}
Procedure · 1. Remove the pivot screw and flat washer from the rear cowl latch. 2. Pull out on the rear corner of the latch to clear the rear cover, then remove the rear cowl latch. WARNING: Ensure latch is fully cleared from the...
Diagnostic · Cause: Non-critical engine condition detected; Engine Guardian system may limit power Test: Key engine to ON and listen for horn signal pattern