Specification
Rear cowl latch: Rear cowl latch - top screws with hex nuts (2) torque
25 Nm conditions={"fastener":"top screws with hex nuts (2)","lb_in":"89"}
Specification
25 Nm conditions={"fastener":"top screws with hex nuts (2)","lb_in":"89"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Unlock the top cowl by pulling out on the rear cowl latch. 2. Lift the top cowl off the engine.
Diagnostic · Cause: Lanyard stop switch not in RUN position
Spec · 15 Nm conditions={"lb-in":"53","lb-ft":"–"}
Procedure · 1. Remove the pivot screw and flat washer from the rear cowl latch. 2. Pull out on the rear corner of the latch to clear the rear cover, then remove the rear cowl latch. WARNING: Ensure latch is fully cleared from the...
Diagnostic · Cause: Key switch is not in the Run position Test: Verify key switch is set to Run position before using the Stop/Start button