Procedure
1. Check the engine oil level 2. Check the lanyard stop switch 3. Inspect the fuel system for leaks 4. Inspect the engine tightness on the transom 5. Check the steering system for binding 6. Check the propeller for damage 7. Inspect the hydraulic steering fittings and hoses for leaks or signs of damage, if equipped
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · SAE 0W-30 Synthetic Power Steering Fluid conditions={"standard":"Fluid level should be slightly below the bottom of the fill hole"}
Diagnostic · Cause: Blown 5-amp fuse in DTS power harness circuit Test: Check DTS power harness circuit fuse. Refer to Maintenance section.
Spec · 75 Nm conditions={"imperial_equivalent":"55 lb-ft","note":"Transom must not yield or crack under this torque; if it does, transom must be strengthened or load carrying area increased"}
Procedure · 1. Recognize intermittent short beeps for six seconds as a non-critical engine condition. 2. Check for operator-correctable conditions: water in fuel filter, cooling system obstruction, or low engine oil level. 3. If ...
Diagnostic · Cause: Lanyard stop switch not properly attached or lanyard too long/slack Test: Verify lanyard is clipped to operator's PFD or wrist and inserted into switch; check lanyard length is 122–152 cm (4–5 ft) when stretched