Diagnostic
5-amp fuse - Starter Motor Will Not Crank the Engine (5-amp fuse)
Cause: Blown 5-amp fuse in DTS power harness circuit Test: Check DTS power harness circuit fuse. Refer to Maintenance section.
Diagnostic
Cause: Blown 5-amp fuse in DTS power harness circuit Test: Check DTS power harness circuit fuse. Refer to Maintenance section.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Cross hatched region on dipstick conditions={"note":"Do not fill to top of operating range; any level within cross hatched region is acceptable"}
Procedure · 1. Turn the key to the OFF position to stop the engine normally. WARNING: Turning the key to the START position while the engine is running will result in engine shut down while leaving the DTS system active. This all...
Spec · 2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Procedure · 1. Remove the fuse puller from the engine. 2. Remove the cover from the fuse holder. 3. Remove the suspected blown fuse and inspect the silver band inside the fuse. If the band is broken, the fuse is blown. 4. Replace...
Diagnostic · Cause: Lanyard stop switch not in RUN position