Procedure
Flushing the Cooling System
1. With the engine turned off, place the outboard in either the operating position (vertical) or in a tilted position.
Procedure
1. With the engine turned off, place the outboard in either the operating position (vertical) or in a tilted position.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 1/2 maximum conditions={"procedure":"Cooling system flush"}
Diagnostic · Cause: Failure to flush internal water passages with fresh water after use in saltwater or polluted water, leading to deposit buildup Test: Inspect and flush internal cooling water passages; refer to Maintenance – Flu...
Spec · 15 minutes conditions={"procedure":"Cooling system flush"}
Procedure · 1. Flush the internal water passages of the outboard with fresh water after each use in salt or polluted water to prevent deposit buildup from clogging water passages. Refer to Maintenance – Flushing the Cooling Syste...
Diagnostic · Cause: Critical sensor detected early indication of a problem Test: Reduce engine speed; move throttle lever back to idle position to reset Engine Guardian. If system determines reset did not correct the problem, Engi...