Procedure
Steering Link Rod Assembly
1. Assemble the steering link rod to the engine with special washer head bolt and self-locking nylon insert locknut. 2. First torque the bolt to specifications. 3. Then torque the locknut to specifications.
Procedure
1. Assemble the steering link rod to the engine with special washer head bolt and self-locking nylon insert locknut. 2. First torque the bolt to specifications. 3. Then torque the locknut to specifications.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Torque to specifications conditions={"note":"Torque bolt first, then torque locknut"}
Diagnostic · Cause: Use of common (non-locking) nuts instead of required self-locking nylon insert locknuts, or improper installation/torque procedures Test: Inspect fasteners for correct part numbers (10-849838 bolt, 11-826709113...
Spec · Torque to specifications conditions={"note":"Torque locknut second, after bolt"}
Procedure · 1. Assemble the steering link rod to the steering cable using two flat washers and a self-locking nylon insert locknut (c). WARNING: Improper fasteners or improper installation procedures can result in loosening or di...
Diagnostic · Cause: Excessive trim-in (trim under) causing the bow to plow into the water; unexpected turn can occur when any turn is attempted or a significant wave is encountered Test: Check trim angle; install stainless steel t...