Specification
Battery terminal wing nut replacement: Wing nut replacement hex nut size 2
3/8 in. conditions={"supply":"included with engine rigging components"}
Specification
3/8 in. conditions={"supply":"included with engine rigging components"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Ensure the battery meets the minimum ratings: 975 CCA and 65 Ah minimum. 2. Install the battery in an enclosed case in accordance with local regulations (required in some states). 3. Ensure battery cable installati...
Diagnostic · Cause: Wing nuts are not approved fasteners for battery terminals Test: Replace wing nuts with supplied 5/16 in. or 3/8 in. hex nuts; torque to 13.5 Nm (120 lb-in.)
Spec · 5/16 in. conditions={"supply":"included with engine rigging components"}
Procedure · 1. Shift outboard to neutral position. 2. Straighten the bent tabs on the propeller nut retainer. 3. Place a block of wood between the gearcase and propeller to hold the propeller, then remove the propeller nut. WARNI...
Diagnostic · Cause: Outboard left tilted up in freezing or near-freezing temperatures, allowing trapped water in the gearcase to freeze Test: Inspect water pump and gearcase components for freeze damage if outboard was stored tilt...