Procedure
1. Shift outboard to neutral position. 2. Straighten the bent tabs on the propeller nut retainer. 3. Place a block of wood between the gearcase and propeller to hold the propeller, then remove the propeller nut. WARNING: Ensure the outboard is in neutral and the propeller is fully secured by the wood block before removing the nut. Tools: Block of wood
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 75 Nm conditions={"alternative_unit_lb_ft":"55"}
Diagnostic · Cause: Remote control is not shifted to the neutral position
Spec · 3/8 in. conditions={"supply":"included with engine rigging components"}
Procedure · 1. Place the outboard in a vertical operating position. 2. Remove the propeller. Refer to Propeller Replacement. 3. Place the drain pan below the outboard. Tools: drain pan
Diagnostic · Cause: ERC not placed in throttle only mode during unmanned helm operation Test: Verify ERC is in throttle only mode; gear position should remain in neutral while RPM can still be increased