Diagnostic
Starter Motor Will Not Crank the Engine
Cause: Remote control is not shifted to the neutral position
Diagnostic
Cause: Remote control is not shifted to the neutral position
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Procedure · 1. Turn the key to the OFF position to stop the engine normally. WARNING: Turning the key to the START position while the engine is running will result in engine shut down while leaving the DTS system active. This all...
Spec · 650 RPM conditions={"note":"With engine fully warmed up"}
Procedure · 1. Place both ERC levers into neutral. Throttle only will not disengage unless the ERC levers are in neutral. 2. Press the THROTTLE ONLY button. The button light will turn off. 3. Confirm the neutral lights stop flash...
Diagnostic · Cause: Lanyard stop switch not in RUN position