Specification
Intake Valve: Valve clearance (cold) – Intake
0.150–0.230 mm (0.0059–0.009 in.) mm conditions={"temperature":"cold"}
Specification
0.150–0.230 mm (0.0059–0.009 in.) mm conditions={"temperature":"cold"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Recognize intermittent short beeps for six seconds as a non-critical engine condition. 2. Check for operator-correctable conditions: water in fuel filter, cooling system obstruction, or low engine oil level. 3. If ...
Diagnostic · Cause: Obstruction in water intake holes in lower unit Test: Stop engine; inspect water intake holes in lower unit for obstruction
Spec · 0.350–0.430 mm (0.0137–0.0169 in.) mm conditions={"temperature":"cold"}
Procedure · 1. Reduce engine speed below 2000 RPM. 2. Tilt the outboard up. Make sure all water intake holes stay submerged at all times. 3. Operate the engine at slow speed only. If engine speed exceeds 2000 RPM, the outboard wi...
Diagnostic · Cause: Obstruction in cooling water intake, water pump failure, or blockage in cooling system Test: Check cooling water intake for obstruction after stopping engine