Specification
Outboard mounting bolt: Outboard mounting bolt diameter
0.500 in. conditions={"quantity":"4"}
Specification
0.500 in. conditions={"quantity":"4"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Apply marine sealer to the shank of the outboard mounting bolts (not the threads). 2. Install the four 0.500 in. diameter outboard mounting bolts with 0.875 in. flat washers, 1.500 in. flat washers, and nylon inser...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · 12.7 mm conditions={"imperial_equivalent":"1/2 in."}
Procedure · 1. Do not install wedges or plates between the transom clamp brackets and the transom (or jack plate). WARNING: Installing wedges or plates between the transom clamp brackets and the transom or jack plate is prohibite...
Diagnostic · Cause: Propeller pitch too low or diameter inappropriate for load Test: Check full throttle RPM under normal load condition