Specification
Outboard transom mounting bolt: Mounting bolt length (standard, supplied)
5.00 in. conditions={"threadLength":"3.25 in.","partNumber":"8M0071543"}
Specification
5.00 in. conditions={"threadLength":"3.25 in.","partNumber":"8M0071543"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Do not install wedges or plates between the transom clamp brackets and the transom (or jack plate). WARNING: Installing wedges or plates between the transom clamp brackets and the transom or jack plate is prohibite...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · ½-20 conditions={"suppliedWithOutboard":"yes","partNumber":"8M0071543"}
Procedure · 1. Ensure the transom mounting surface is flat within 3.17 mm (0.125 in.). No step in the transom mounting surface is allowed. WARNING: No step in the transom mounting surface is allowed. No gap between the transom cl...
Diagnostic · Cause: Boat transom is yielding under bolt torque; transom construction may not be adequate Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt using a dial torque wrench and observe dial reading Expected: To...