Specification
Outboard transom mounting bolt: Mounting bolt thread size (standard)
½-20 conditions={"suppliedWithOutboard":"yes","partNumber":"8M0071543"}
Specification
½-20 conditions={"suppliedWithOutboard":"yes","partNumber":"8M0071543"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Do not install wedges or plates between the transom clamp brackets and the transom (or jack plate). WARNING: Installing wedges or plates between the transom clamp brackets and the transom or jack plate is prohibite...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · 5.00 in. conditions={"threadLength":"3.25 in.","partNumber":"8M0071543"}
Procedure · 1. Apply marine sealer to the shank of the outboard mounting bolts (not the threads). 2. Install the four 0.500 in. diameter outboard mounting bolts with 0.875 in. flat washers, 1.500 in. flat washers, and nylon inser...
Diagnostic · Cause: Boat transom is yielding under bolt torque; transom construction may not be adequate Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt using a dial torque wrench and observe dial reading Expected: To...