Specification
Rear cover: Rear cover - screws (2) torque
15 Nm conditions={"fastener":"screws (2)","lb_in":"53"}
Specification
15 Nm conditions={"fastener":"screws (2)","lb_in":"53"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Secure the flywheel cover to the rear mounting posts with two bolts with washers. (torque: 10 Nm) Parts: Flywheel cover bolt and washer
Diagnostic · Cause: Wing nuts are not approved fasteners for battery terminals Test: Replace wing nuts with supplied 5/16 in. or 3/8 in. hex nuts; torque to 13.5 Nm (120 lb-in.)
Spec · 15 Nm conditions={"lb-in":"53","lb-ft":"–"}
Procedure · 1. Install the upper half of the flywheel cover subassembly to the lower flywheel cover subassembly. Ensure the upper flywheel cover latch opening is properly secured to the lower flywheel cover. 2. Push the two subas...
Diagnostic · Cause: Loose engine fasteners causing transom bracket failure Test: Verify all engine fasteners are tightened to specified torque