Specification
Transom mounting hardware: Number of mounting bolts
4 conditions={"upper_holes":"2","lower_holes":"2"}
Specification
4 conditions={"upper_holes":"2","lower_holes":"2"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Check the decal on the transom bracket reminding you to verify fasteners securing the outboard to the transom before each use. WARNING: Failure to correctly fasten the outboard could result in the outboard propelli...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · 12.7 mm conditions={"imperial_equivalent":"1/2 in."}
Procedure · 1. Determine the strength of the boat transom. The outboard mounting locknuts and bolts must be able to hold 75 Nm (55 lb‑ft) of torque without the boat transom yielding or cracking. (torque: 75 Nm) WARNING: If the bo...
Diagnostic · Cause: Boat transom is yielding under bolt torque; transom construction may not be adequate Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt using a dial torque wrench and observe dial reading Expected: To...