Specification
Transom mounting surface: Transom mounting surface flatness tolerance
0.125 in conditions={"note":"No step in the transom mounting surface is allowed"}
Specification
0.125 in conditions={"note":"No step in the transom mounting surface is allowed"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Ensure the transom mounting surface is flat within 3.17 mm (0.125 in.). No step in the transom mounting surface is allowed. WARNING: No step in the transom mounting surface is allowed. No gap between the transom cl...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · 3.17 mm conditions={"note":"No step in the transom mounting surface is allowed"}
Procedure · 1. Ensure the accessory mounting plate does not rest in the radius of the transom clamp bracket, maintaining a minimum clearance of 3.175 mm (0.125 in.) — refer to Figure 1. WARNING: Installation must not create inter...
Diagnostic · Cause: Boat transom is yielding under bolt torque; transom construction may not be adequate Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt using a dial torque wrench and observe dial reading Expected: To...