Engine failing to start

Related KB links

• Oil Pump: Pre-start oil pump priming cranks

  Spec · 10 crank cycles conditions={"applicability":"First start after engine reassembly or off-season storage"}

• Daily Pre/Post-Operation Inspection

  Procedure · 1. Fuel System – Check the amount of fuel in the tank. Replenish as needed. WARNING: Do not use outboard motor if any abnormality is found during pre-operation check or it could result in severe damage to the motor or...

• Engine Oil: Oil replenishment target level

  Spec · Middle dipstick mark conditions={"starting_level":"low or at minimum mark"}

• Prime oil pump after engine reassembly or off-season storage

  Procedure · 1. Disconnect the stop switch lock. 2. Crank the engine approximately 10 times in order to prime the oil pump. WARNING: Perform this step before starting engine for the first time after reassembling engine or off-seas...

• Engine starting but stopping soon

  Diagnostic · Cause: Faulty oil pressure switch