Warning lamp ON

Related KB links

• Electronic Safety Governor (Low Speed ESG): Low Speed ESG RPM Limit

  Spec · 2800 rpm conditions={"trigger":"Cooling water fault, oil pressure fault, or sensor fault"}

• Engine oil replacement

  Procedure · 1. Stop the engine and leave it in a vertical position for over 5 minutes. WARNING: Do not fill engine oil just after operation; allow engine to cool to avoid injury from high temperatures. 2. Tilt up the outboard mot...

• Tohatsu MFS6/8/9.8B EFT/EPT: part_24

  Spec · Warning Lamp

• Daily Pre/Post-Operation Inspection

  Procedure · 1. Fuel System – Check the amount of fuel in the tank. Replenish as needed. WARNING: Do not use outboard motor if any abnormality is found during pre-operation check or it could result in severe damage to the motor or...

• Low oil pressure with continuous buzzer, LED ON, and Low Speed ESG active

  Diagnostic · Cause: Low oil pressure (oil pressure switch ON) Test: Continuous buzzer sound; LED lamp ON; Low Speed ESG activated — ignition suppressed and fueling disabled; engine speed controlled under 2800 rpm