Procedure
1. Attach the outboard motor to the boat by tightening the clamp screws by turning their handles. 2. Use bolts (8 × 85) with nuts and washers to secure the outboard motor brackets on the transom board. 3. Secure the outboard motor with a rope to prevent loss overboard. WARNING: A rope is not included in the standard accessories. Parts: Bolt (8 × 85), Nut, Washer, Clamp screw
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 8 × 85 mm conditions={"type":"Manual tilt type"}
Diagnostic · Cause: Outboard motor tilted up or down while swimmer(s) or passenger is nearby; person caught between outboard motor body and clamp bracket.
Spec · 12 × 105 mm conditions={"type":"PTT type"}
Procedure · 1. Drill holes in the transom board at 4 points — up and down, right and left of the clamp bracket. WARNING: Do not reuse Nylon locking nut. 2. Apply sealing material (e.g. silicone sealant) between the bolts and the ...
Diagnostic · Cause: Risk of outboard motor falling while tilted, even when supported by a support bar. Test: Visual inspection — confirm motor is fully secured before any personnel work near or under it.