Specification
Outboard motor bracket clamp / transom board: Manual tilt mounting bolt size
8 × 85 mm conditions={"type":"Manual tilt type"}
Specification
8 × 85 mm conditions={"type":"Manual tilt type"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Attach the outboard motor to the boat by tightening the clamp screws by turning their handles. 2. Use bolts (8 × 85) with nuts and washers to secure the outboard motor brackets on the transom board. 3. Secure the o...
Diagnostic · Cause: Outboard motor tilted up or down while swimmer(s) or passenger is nearby; person caught between outboard motor body and clamp bracket.
Spec · 12 × 105 mm conditions={"type":"PTT type"}
Procedure · 1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer
Diagnostic · Cause: Outboard motor tilted too high, causing air to be sucked through the water inlet Test: Check that the cooling water intake (water inlet) remains fully submerged during shallow water drive