Procedure
1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 12 × 105 mm conditions={"type":"PTT type"}
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 8 × 85 mm conditions={"type":"Manual tilt type"}
Procedure · 1. Drill holes in the transom board at 4 points — up and down, right and left of the clamp bracket. WARNING: Do not reuse Nylon locking nut. 2. Apply sealing material (e.g. silicone sealant) between the bolts and the ...
Diagnostic · Cause: Outboard motor tilted up or down while swimmer(s) or passenger is nearby; person caught between outboard motor body and clamp bracket.