Specification
Outboard motor bracket / transom board: PTT type mounting bolt size
12 × 105 mm conditions={"type":"PTT type"}
Specification
12 × 105 mm conditions={"type":"PTT type"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Use bolts (12 × 105) with small-diameter washers, nuts, and large-diameter washers to secure the outboard motor brackets on the transom board. Parts: Bolt (12 × 105), Washer (small diameter), Nut, Washer (large dia...
Diagnostic · Cause: Short-circuit or electrical overload in the system Test: Remove fuse and visually inspect for blown condition; replace with fuse of identical specified rating only.
Spec · 8 × 85 mm conditions={"type":"Manual tilt type"}
Procedure · 1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer
Diagnostic · Cause: Outboard motor tilted up or down while swimmer(s) or passenger is nearby; person caught between outboard motor body and clamp bracket.