Procedure
1. Use bolts (12 × 105) with small-diameter washers, nuts, and large-diameter washers to secure the outboard motor brackets on the transom board. Parts: Bolt (12 × 105), Washer (small diameter), Nut, Washer (large diameter)
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 12 × 105 mm conditions={"type":"PTT type"}
Diagnostic · Cause: Corrosion of the anode causing bolts to loosen over time Test: Manual check and re-tightening of all anode attaching bolts at each inspection
Spec · 8 × 85 mm conditions={"type":"Manual tilt type"}
Procedure · 1. Attach the outboard motor to the boat by tightening the clamp screws by turning their handles. 2. Use bolts (8 × 85) with nuts and washers to secure the outboard motor brackets on the transom board. 3. Secure the o...
Diagnostic · Cause: Short-circuit or electrical overload in the system Test: Remove fuse and visually inspect for blown condition; replace with fuse of identical specified rating only.