Procedure
Power Tilt – Tilt Down
1. While slightly tilting the outboard motor up, release the tilt stopper from the set-up position. 2. Operate the Power Tilt switch and tilt the outboard motor down until the motor touches the thrust rod.
Procedure
1. While slightly tilting the outboard motor up, release the tilt stopper from the set-up position. 2. Operate the Power Tilt switch and tilt the outboard motor down until the motor touches the thrust rod.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Oil level must reach the bottom line of the plug hole conditions={"motorPosition":"Tilted up and locked with tilt stopper","tankPosition":"Vertical"}
Procedure · 1. Release the tilt stopper from the set-up position while slightly tilting up the outboard motor. 2. Operate the Power Tilt switch and tilt the outboard motor down until the motor touches the thrust rod.
Diagnostic · Cause: Entrapped air in the Power Tilt unit Test: Perform air purging procedure: set manual release valve to Manual, tilt motor up/down 5–6 times manually, then close valve to Power side
Spec · 5–6 times conditions={"procedure":"Tilt outboard motor manually up/down with manual release valve set to Manual side"}
Diagnostic · Cause: Dead battery or failed power tilt switch. Test: Attempt to operate the power tilt switch; if no response, check battery charge and switch continuity.