Procedure
Starting the Engine in a Test Tank
1. Ensure water level is at least 10 cm (4 in.) above the anti-ventilation plate to avoid overheating of the engine. 2. Run at idling only. 3. Remove the propeller. (See page 72)
Procedure
1. Ensure water level is at least 10 cm (4 in.) above the anti-ventilation plate to avoid overheating of the engine. 2. Run at idling only. 3. Remove the propeller. (See page 72)
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 10 cm (4 in.) conditions={"context":"To avoid overheating of the engine"}
Diagnostic · Cause: Outboard motor tilted too high, causing air to be sucked through the water inlet Test: Check that the cooling water intake (water inlet) remains fully submerged during shallow water drive
Spec · 10 cm (4 in.) conditions={"purpose":"To avoid overheating and water pump damage during test tank engine start"}
Procedure · 1. Remove the propeller before starting the engine in the test tank. WARNING: Do not start engine without removing propeller — turning propeller out in the open may lead to personal injury. 2. Place the outboard motor...
Diagnostic · Cause: Incorrect propeller selection