Specification
Test tank / Water pump: Minimum water level above anti-ventilation plate for test tank operation
10 cm (4 in.) conditions={"purpose":"To avoid overheating and water pump damage during test tank engine start"}
Specification
10 cm (4 in.) conditions={"purpose":"To avoid overheating and water pump damage during test tank engine start"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Ensure water level is at least 10 cm (4 in.) above the anti-ventilation plate to avoid overheating of the engine. 2. Run at idling only. 3. Remove the propeller. (See page 72)
Diagnostic · Cause: Trim angle set too high (excessive trim up) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 10 cm (4 in.) conditions={"purpose":"Prevent engine overheating during test tank operation"}
Procedure · 1. Remove the propeller before starting the engine in the test tank. (See page 70) WARNING: Do not start engine without removing propeller; accidentally turning propeller could cause personal injury. 2. Ensure the wat...
Diagnostic · Cause: Trim angle set too high Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface