Procedure
Trim angle adjustment – Manual tilt RC type (Transom angle adjustment)
1. Stop the engine. 2. Shift into forward. 3. Raise the outboard motor to the tilt up position.
Procedure
1. Stop the engine. 2. Shift into forward. 3. Raise the outboard motor to the tilt up position.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · ~40 degrees conditions={"type":"Manual tilt (MF, EF type)","shift_lever":"Neutral or Forward"}
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 61 degree conditions={"transom_angle":"-12°"}
Procedure · 1. Stop the engine. 2. Shift into forward. 3. Raise the outboard motor to the tilt up position. 4. Change the trim lock pin position using the preset knob: (1) Preset knob, (2) Pull, (3) Higher, (4) Lower. 5. Reinstal...
Diagnostic · Cause: Trim angle set too high Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface