Procedure
1. Stop the engine. 2. Shift into forward. 3. Raise the outboard motor to the tilt up position. 4. Change the trim lock pin position using the preset knob: (1) Preset knob, (2) Pull, (3) Higher, (4) Lower. 5. Reinstall the preset knob securely. 6. Gently lower the outboard motor.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · ~40 degrees conditions={"type":"Manual tilt (MF, EF type)","shift_lever":"Neutral or Forward"}
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 5–6 times conditions={"procedure":"Tilt outboard motor manually up/down with manual release valve set to Manual side"}
Procedure · 1. Stop the engine. 2. Raise the outboard motor manually. 3. Pull the preset knob to unlock. 4. Change the trim lock pin position: move pin to a higher hole to increase trim angle, or a lower hole to decrease trim ang...
Diagnostic · Cause: Trim angle set too high Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface