Procedure
1. Stop the engine. 2. Raise the outboard motor manually. 3. Pull the preset knob to unlock. 4. Change the trim lock pin position: move pin to a higher hole to increase trim angle, or a lower hole to decrease trim angle. 5. Reinstall the preset knob securely. 6. Gently lower the outboard motor. WARNING: Be sure to tilt the outboard motor down slowly.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · ~40 degrees conditions={"type":"Manual tilt (MF, EF type)","shift_lever":"Neutral or Forward"}
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · Direct trim tab toward A (left from rear of boat) conditions={"location":"Under anti-ventilation plate"}
Procedure · 1. Stop the engine. 2. Shift into forward. 3. Raise the outboard motor to the tilt up position. 4. Change the trim lock pin position using the preset knob: (1) Preset knob, (2) Pull, (3) Higher, (4) Lower. 5. Reinstal...
Diagnostic · Cause: Trim angle set too high Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface