Procedure
1. Stop the engine. 2. Shift into neutral. 3. Raise the outboard motor to the tilt up position. 4. Change the thrust rod position: (1) Push in, (2) Rise the stopper, (3) Pull out. 5. Reinstall the thrust rod securely. 6. Gently lower the outboard.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · ~40 degrees conditions={"type":"Manual tilt (MF, EF type)","shift_lever":"Neutral or Forward"}
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · Hull horizontal during operation conditions={"indicator":"hull runs level"}
Procedure · 1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Remove the thrust rod: (1) Push in, (2) Rise the stopper, (3) Pull out. 5. Reinstall the thrust rod in the desired position securel...
Diagnostic · Cause: Trim angle set too high Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface