Procedure
1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Remove the thrust rod: (1) Push in, (2) Rise the stopper, (3) Pull out. 5. Reinstall the thrust rod in the desired position securely. 6. Gently tilt down the outboard motor.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · ~40 degrees conditions={"type":"Manual tilt (MF, EF type)","shift_lever":"Neutral or Forward"}
Diagnostic · Cause: Outboard motor tilted too high, causing air to be sucked through the water inlet Test: Check that the cooling water intake (water inlet) remains fully submerged during shallow water drive
Spec · -5 to 6 degree conditions={"transom_angle":"-12°"}
Procedure · 1. Stop the engine. 2. Shift into neutral. 3. Raise the outboard motor to the tilt up position. 4. Change the thrust rod position: (1) Push in, (2) Rise the stopper, (3) Pull out. 5. Reinstall the thrust rod securely....
Diagnostic · Cause: Improper trim angle (excessive trim up or down) Test: Reduce speed immediately; stop boat and inspect thrust rod / priset knob position Expected: Thrust rod / priset knob positioned so hull runs horizontal