Diagnostic
Cause: Improper trim angle (excessive trim up or down) Test: Reduce speed immediately; stop boat and inspect thrust rod / priset knob position Expected: Thrust rod / priset knob positioned so hull runs horizontal
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Direct trim tab toward A (left from rear of boat) conditions={"location":"Under anti-ventilation plate"}
Procedure · 1. Stop the engine before adjusting the trim angle. WARNING: Do not put hand or finger between the outboard motor body and clamp bracket when adjusting trim angle — the outboard motor body may fall and cause injury. 2...
Spec · Direct trim tab toward B (right from rear of boat) conditions={"location":"Under anti-ventilation plate"}
Procedure · 1. Stop the engine before adjusting the trim angle. WARNING: Do not put hand or finger between the outboard motor body and clamp bracket when adjusting trim angle to prevent possible injury. 2. Select a trim position ...
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface