Specification
Anti-ventilation plate: Anti-ventilation plate running angle
Parallel to water surface conditions={"during":"operation"}
Specification
Parallel to water surface conditions={"during":"operation"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Assess hull attitude during operation: the anti-ventilation plate should run parallel to the water surface and the hull should be horizontal. 2. If the bow rises too high above horizontal, set the thrust rod (or pr...
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 5–25 mm (0.2–1 in) conditions={"context":"Correct mounting height range above water surface"}
Procedure · 1. Stop the engine before adjusting the trim angle. WARNING: Do not put hand or finger between the outboard motor body and clamp bracket when adjusting trim angle — the outboard motor body may fall and cause injury. 2...
Diagnostic · Cause: Trim angle set too high (excessive trim up) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface