Specification
Clamp bracket mounting hardware: Clamp bracket bolt size
8 × 85 mm conditions={"fastenerType":"Bolt with flat washer and nylon locking nut"}
Specification
8 × 85 mm conditions={"fastenerType":"Bolt with flat washer and nylon locking nut"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer
Diagnostic · Cause: Outboard motor tilted up or down while swimmer(s) or passenger is nearby; person caught between outboard motor body and clamp bracket.
Spec · 8 × 85 mm conditions={"type":"Manual tilt type"}
Procedure · 1. Drill holes in the transom board at 4 points — up and down, right and left of the clamp bracket. WARNING: Do not reuse Nylon locking nut. 2. Apply sealing material (e.g. silicone sealant) between the bolts and the ...
Diagnostic · Cause: Hand placed between swivel bracket and stern bracket while tilting up or down.