Specification
MFS 8/9.8B MF variant: Trim Angle (MF)
-8 to 12 degree conditions={"transom_angle":"-12°"}
Specification
-8 to 12 degree conditions={"transom_angle":"-12°"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Stop the engine. 2. Shift into forward. 3. Raise the outboard motor to the tilt up position.
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · -5 to 6 degree conditions={"transom_angle":"-12°"}
Procedure · 1. Assess hull attitude during operation: the anti-ventilation plate should run parallel to the water surface and the hull should be horizontal. 2. If the bow rises too high above horizontal, set the thrust rod (or pr...
Diagnostic · Cause: Trim angle set too high (excessive trim up) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface