Specification
MFS 8/9.8B: Transom Height (L)
562 mm (in: 22.1) conditions={"model":"MFS 8/9.8B","transom":"L"}
Specification
562 mm (in: 22.1) conditions={"model":"MFS 8/9.8B","transom":"L"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Lock the tilt stopper. 5. Change the trim lock pin position as shown in the picture: (1) Trim lock pin, (2) Higher, (3) Lower.
Diagnostic · Cause: Transom too high or too low
Spec · 562 mm (22.1 in) conditions={"transom":"L (Long)"}
Procedure · 1. Attach the outboard motor to the boat by tightening the clamp screws by turning their handles. 2. Use bolts (8 × 85) with nuts and washers to secure the outboard motor brackets on the transom board. 3. Secure the o...
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface