Specification
MFS 8/9.8B: Transom Height (UL)
689 mm (27.1 in) conditions={"transom":"UL (Ultra Long)"}
Specification
689 mm (27.1 in) conditions={"transom":"UL (Ultra Long)"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Lock the tilt stopper. 5. Change the trim lock pin position as shown in the picture: (1) Trim lock pin, (2) Higher, (3) Lower.
Diagnostic · Cause: Transom too high or too low
Spec · 689 mm (in: 27.1) conditions={"model":"MFS 8/9.8B","transom":"UL"}
Procedure · 1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface