Specification
MFS 8/9.8B: Trim Angle
-8 to 8 degree conditions={"model":"MFS 8/9.8B","transom_angle":"-12°"}
Specification
-8 to 8 degree conditions={"model":"MFS 8/9.8B","transom_angle":"-12°"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Stop the engine. 2. Shift into forward. 3. Raise the outboard motor to the tilt up position.
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · -8 to 12 degree conditions={"transom_angle":"-12°"}
Procedure · 1. Stop the engine. 2. Operate the Power Tilt switch and raise the outboard motor to the tilt-up position. 3. Lock the tilt with the Tilt stopper. 4. Change the trim lock pin position: move pin to a higher hole to inc...
Diagnostic · Cause: Trim angle set too high (excessive trim up) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface