Model Name: Model Name Decode: T (Tilt)

Related KB links

• Trim angle adjustment – Power tilt type (transom angle)

  Procedure · 1. Stop the engine. 2. Operate the Power Tilt switch and raise the outboard motor to the tilt-up position. 3. Lock the tilt with the Tilt stopper. 4. Change the trim lock pin position: move pin to a higher hole to inc...

• Poor tilting movement and increased noise from Power Tilt unit

  Diagnostic · Cause: Entrapped air in the Power Tilt unit Test: Perform air purging procedure: set manual release valve to Manual, tilt motor up/down 5–6 times manually, then close valve to Power side

• Model Name: Model Name Decode: Blank (Tilt)

  Spec · Manual tilt

• Power Tilt – Tilt Up

  Procedure · 1. Operate the Power Tilt switch to tilt the outboard motor up. 2. Lock the tilt with the Tilt stopper after the outboard motor has been fully tilted up.

• Power tilt switch inoperative

  Diagnostic · Cause: Battery is dead Test: Check battery charge; if dead, use the manual relief valve to allow manual tilting