Specification
Nylon locking nut: Nylon locking nut size – EP/EFT
8 mm conditions={"variant":"EP/EFT","quantity":"2"}
Specification
8 mm conditions={"variant":"EP/EFT","quantity":"2"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer
Diagnostic · Cause: Object or debris blocking the cooling water check port Test: Inspect cooling water check port for blockage; remove any debris found
Spec · 8 mm conditions={"variant":"EPT","quantity":"4"}
Procedure · 1. Drill holes in the transom board only at left and right of the lower side of the clamp bracket (2 holes total). WARNING: Do not reuse Nylon locking nut. 2. Apply sealing material (e.g. silicone sealant) between the...
Diagnostic · Cause: Foreign matter blocking gear case or propeller, or cooling water circuit failure Test: Verify cooling water discharge from water check port at idle speed; remove foreign matter from gear case and propeller