Procedure

Mounting outboard motor to transom board (EP/EFT type)

1. Drill holes in the transom board only at left and right of the lower side of the clamp bracket (2 holes total). WARNING: Do not reuse Nylon locking nut. 2. Apply sealing material (e.g. silicone sealant) between the bolts and the transom board holes before tightening. 3. Attach the outboard motor using the supplied bolts (8 × 85), washers, and nylon locking nuts. WARNING: Tighten the bolts securely, otherwise the outboard motor could fall down. Tools: drill Parts: Bolt (8 × 85), Washer, Nylon locking nut

Ask Boat Guru about this

Open chat with this engine and topic preloaded so you can troubleshoot faster.

Ask Boat Guru about this

Mounting outboard motor to transom board (EP/EFT type) — Tohatsu MFS9.8 | Boat Guru

Mounting outboard motor to transom board (EP/EFT type)

Ask Boat Guru about this

Mounting outboard motor to transom board (EP/EFT type)

Ask Boat Guru about this

Related KB links