Specification
Outboard motor mounting: Anti-ventilation plate position below hull bottom (minimum)
0.2 in conditions={"reference":"Bottom of hull"}
Specification
0.2 in conditions={"reference":"Bottom of hull"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Verify the boat's certification plate and ensure the outboard motor horsepower does not exceed the maximum allowable horsepower rating shown on the plate. WARNING: Do not equip your boat with an outboard motor that...
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 5 mm conditions={"reference":"Bottom of hull"}
Procedure · 1. Assess hull attitude during operation: the anti-ventilation plate should run parallel to the water surface and the hull should be horizontal. 2. If the bow rises too high above horizontal, set the thrust rod (or pr...
Diagnostic · Cause: Trim angle set too high Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface