Specification
Outboard motor mounting position: Anti-ventilation plate to water surface clearance
5–25 mm (0.2–1 in) conditions={"note":"Minimum distance between bottom cowl and water surface to prevent water ingress"}
Specification
5–25 mm (0.2–1 in) conditions={"note":"Minimum distance between bottom cowl and water surface to prevent water ingress"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Set the outboard motor to the appropriate position, ensuring 5–25 mm (0.2–1 in) clearance between the anti-ventilation plate and the water surface. 2. Tighten the clamp screws by turning their handles. Do NOT use t...
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 5 mm conditions={"reference":"Bottom of hull"}
Procedure · 1. Verify the boat's certification plate and ensure the outboard motor horsepower does not exceed the maximum allowable horsepower rating shown on the plate. WARNING: Do not equip your boat with an outboard motor that...
Diagnostic · Cause: Trim angle set too high Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface