Specification
Remote control cable: Remote control cable extra length
300-450 mm conditions={"note":"Cable should be 300-450mm (11.8-17.7in) longer than the measured route distance"}
Specification
300-450 mm conditions={"note":"Cable should be 300-450mm (11.8-17.7in) longer than the measured route distance"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Measure the distance from the remote control box to the outboard motor along the intended cable route. 2. Prepare a cable that is 300–450 mm (11.8–17.7 in) longer than the measured distance. 3. Temporarily pull the...
Diagnostic · Cause: Low oil pressure (oil pressure switch ON) Test: Continuous buzzer sound; LED lamp ON; Low Speed ESG activated — ignition suppressed and fueling disabled; engine speed controlled under 2800 rpm
Spec · Counter-clockwise conditions={"controlType":"Side mount / EP / EPT remote control"}
Procedure · 1. Apply sealing agent, such as silicone 2. Be sure to tighten the mounting bolt 3. Shift cable 4. Throttle cable 5. Cable harness B 6. Remote control device
Diagnostic · Cause: Load on engine becomes light, triggering High Speed ESG which suppresses ignition to limit speed Test: Check propeller for bent or damaged blades Expected: Engine speed controlled under 6300 min⁻¹ (rpm)