Transom Height: Shaft Length - Ultra Long (UL)

Related KB links

• Remote control cable installation

  Procedure · 1. Measure the distance from the remote control box to the outboard motor along the intended cable route. 2. Prepare a cable that is 300–450 mm (11.8–17.7 in) longer than the measured distance. 3. Temporarily pull the...

• OTHERS - Engine speed abnormally low / Boat speed low / Overheating of engine / Warning lamp ON

  Diagnostic · Cause: Transom too high or too low

• Transom Height: Shaft Length - Long (L)

  Spec · 20 in

• Trim angle adjustment – Power tilt type: Transom angle adjustment

  Procedure · 1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Lock the tilt stopper. 5. Change the trim lock pin position as shown in the picture: (1) Trim lock pin, (2) Higher, (3) Lower.

• Engine failing to start / Engine starting but stopping soon / Poor idling / Poor acceleration / Engine speed abnormally high / Engine speed abnormally low / Boat speed low / Overheating of engine / Warning lamp ON

  Diagnostic · Cause: Transom too high or too low